| Description |
| Sensor type | 3-cup anemometer |
| |
| Applications | wind resource assessment |
| meteorological studies |
| environmental monitoring |
| |
| Sensor range | 1 m/s to 96 m/s (2.2 mph to 214 mph) (highest recorded) |
| |
| Instrument compatibility | all NRG loggers |
| |
| Output signal |
| Signal type | low level AC sine wave, frequency linearly proportional to windspeed |
| |
| Transfer function | m/s = (Hz x 0.765) + 0.35 |
| [miles per hour = (Hz x 1.711) + 0.78] |
| |
| Accuracy | within 0.1 m/s (0.2 mph) for the range 5 m/s to 25 m/s (11 mph to 55 mph) |
| |
| Output voltage at threshold | 80 mV (peak to peak) minimum |
| |
| Output voltage at 60Hz | 12 V (peak to peak) typical |
| output amplitude NOT proportional to windspeed |
| |
| Calibration | each anemometer individually calibrated, calibration reports provided via electronic download |
| |
| Output signal range | 0 Hz to 125 Hz (highest recorded) |
| |
| Response characteristics |
| Threshold | 0.78 m/s (1.75 miles per hour) |
| |
| Distance constant (63% recovery) | 3.0 m (10 feet) |
| |
| Moment of inertia | 68 x 10-6 S-ft2 |
| |
| Swept diameter of rotor | 190 mm (7.5 inches) |
| |
| Installation |
| Mounting | onto a 13 mm (0.5 inch) diameter mast with cotter pin and set screw |
| |
| Tools required | 0.25 inch nut driver, petroleum jelly, electrical tape |
| |
| Environmental |
| Operating temperature range | -55 °C to 60 °C (-67 °F to 140 °F) |
| |
| Operating humidity range | 0 to 100% RH |
| |
| Physical |
| Connections | 4-40 brass hex nut/post terminals |
| |
| Weight | 0.14 kg (0.3 pounds) |
| |
| Dimensions | 3 cups of conical cross-section, 51 mm (2 inches) dia. |
| 81 mm (3.2 inches) overall assembly height |
| |
| Materials |
| Cups | one piece injection-molded black polycarbonate |
| |
| Body | housing is black ABS plastic |
| |
| Shaft | beryllium copper, fully hardened |
| |
| Bearing | modified Teflon, self-lubricating |
| |
| Magnet | Indox 1, 25 mm (1 inch) diameter, 13 mm (0.5 inch) long, 4 poles |
| |
| Coil | single coil, bobbin wound, 4100 turns of #40 wire, shielded for ESD protection |
| |
| Boot | protective PVC sensor terminal boot included |
| |
| Terminals | brass |