C2T系列开环型可拆卸霍尔电流传感器的初、次级之间是绝缘的,用于测量直流电流。
C2T series dismountable hall effect current Sensor is an open loop device based on the measuring principle of the hall effect, with a galvanic isolation between primary and secondary circuit. It provides accurate electronic measurement of DC currents.
Type | C2T-50A | C2T-100A | C2T-200A | C2T-400A | C2T-600A | 单位Unit |
额定输入电流(Ipn)Rated current(Ipn) | ±50 | ±100 | ±200 | ±400 | ±600 | A |
测量电流范围(Ip)Measure range(Ip) | 0—±75 | 0—±150 | 0—±300 | 0—±600 | 0—±900 | A |
额定输出电压Rated output | @Ip=±Ipn ±2±1% | V |
零点电压Zero voltage | @Ip=0 5±0.5% | V |
电源电压Supply voltage | +12,+15,+24 | V |
功耗电流Power Consumption | ≤15 | mA |
零点失调电压Zero offset voltage | @Ip=0 ±20 | mV |
磁失调电压Magnetic offset | @Ip=±Ipn-0 ±15 | mV |
失调电压温漂Offset drift | @ -40~+85℃ ≤±0.5 | mV/℃ |
输出电压温漂Output drift | @ -40~+85℃ ≤±0.5 | mV/℃ |
线性度Linearity | @Ip=0-±Ipn ≤1 | %FS |
响应时间Response time | @50A/μS, 10%-90% ≤7 | μs |
绝缘电压Galvanic isolation | @ 50HZ,AC,1min 2.5 | KV |
· 交流变速驱动器
AC variable speed drives
· 直流电机驱动静态转换器
Static converters for DC motor drives
· 变频调速系统
Variable speed drives
· 电焊机
Power supplies for welding applications
· 通讯电源
Battery supplied applications
· 不间断电源UPS
Uninterruptible Power Supplies (UPS)
· 开关电源
Switched Mode Power Supplies (SMPS)
Remarks:
1. All dimensions are in mm.
2. General tolerance ±1mm.
3. Elucidation: 1:+12V 2:OV 3:V0UT 4:NC
1. 当待测电流从传感器穿过,即可在输出端测得电压大小。(注意:错误的接线可能导致传感器损坏) When the current will be measured goes through a sensor, the voltage will be measured at the output end. (Note: The false wiring may result in the damage of the sensor)
2. 传感器的输出幅度可根据用户需要进行适当调节。
Customs can adjust output amplitude of the sensor by needs.
3. 可按用户需求定制不同额定输入电流和输出电压的传感器。
Custom design in the different rated input current and the output voltage are available.
· UL94-V0.
· EN60947-1:2004
· IEC60950-1:2001
· EN50178:1998
·
SJ 20790-2000
| 数值 Value | 单位Unit |
工作温度 (TA)Operating temperature | -40 to +85 | ℃ |
储存温度 (TS)Storage temperature | -40 to +125 | ℃ |
毛重(约) (M)Mass(approx) | 65 | g |